Filters
      Back to home
      1. Knowledge Base & Help Center
      2. Products
      3. Filters

      How To: Replace 950P Filters?

      Replacing both the pre-filter and main filter in your 950P Unit should only take you about ten minutes.

      To Replace The Intellipure 950P Pre-Filter:

      ⚠️  Caution: Always disconnect power to the unit before servicing

      1. Lock the two front wheels to secure your unit.
      2. Remove the filter access door by unlocking the four quarter-turn latches. Removing the filter access door may require a firm pull to release fully.
      3. Slide the old pre-filter out of the filter channel.
      4. Slide the new filter into the channel in accordance with the direction of the airflow label.
      5. Ensure the pre-filter is firmly in place or the unit will not turn on.

      To Replace The Intellipure 950P V-Bank Main Filter:

      ⚠️  Caution: Always disconnect power to the unit before servicing

      1. Lock the two front wheels to secure your unit.
      2. Remove the filter access door by unlocking the four quarter-turn latches. Removing the filter access door may require a firm pull to release fully.
      3. Disconnect the red wire lead from the multiplier.
      4. Unlock the V-bank filter with a flat screwdriver or a similar tool by turning the lock cylinder in accordance with the labeled direction.
      5. Using a firm pull, remove the old filter and high-energy grid assembly out of the filter access opening.
      6. Once taken apart, inspect and clean the inside of the unit to ensure it functions properly when reassembled.
      7. Separate the high-energy grid from the old filter by turning and unlocking the three-panel clips.
      8. Apply the high-energy grid to the new filter. Secure the grid to the filter by turning and locking the clips.
      9. Slide the filter back into the unit, ensuring the arrow is pointing toward the supply/outlet end of the unit.
      10. Lock the V-bank with the proper tool by turning the lock cylinder. You can reconnect the high-voltage lead when the filter is back in place.

      To Close The Intellipure 950P Unit After Replacing The Filter:

      1. Return the filter access door to the unit.
      2. Position the threaded pin into the hole of the control panel to activate the safety switch. Without proper alignment of the pin, the unit will not turn on.

      Click here to purchase your pre-filter replacement!